Specifications
AE/LZB 119 1897 R1A SOFTWARE CONFIGURATION
48
6.2.2.10 Radio Status Dialog Box
The Configuration Editor’s Radio Status dialog box, shown selected in the following figure, provides configuration
functions for the console’s radio status code initialization file—STATUS.INI. This INI file is a database for the 128 unique
RSM/RTT status codes which the console provides. This configuration must be performed before RSM and/or RTT modules
are “added” to a console screen initialization file via the UDS Configurator program. The dialog box also provides
enable/disable selection for the “route all RSM/RTT messages” setting. Save any changes made by clicking the <Save>
command button.
Figure 6-17 — Configuration Editor’s Radio Status Dialog Box
NOTE
Since RSM and RTT are feature licensed options, configurations described in this section do not guarantee RSM
and/or RTT operations will be possible within the console application. Refer to section 6.2.7 in this manual (page
57) for additional information on the console’s feature licensed options.
6.2.2.10.1 Defining Status Codes
In the console application, each RSM or RTT module is assigned a status code for RSM/RTT radio unit status message
operations. This assignment configuration occurs before the console application is started when a particular RSM or RTT
module is “added” to the console’s screen initialization file via the UDS Configurator program. See manual
AE/LZB 119 1896 for UDS Configurator program operation information.
Since the UDS Configurator program reads RSM/RTT status code definitions stored in STATUS.INI at program start-up,
RSM/RTT status code definitions should be accomplished with the Configuration Editor’s Radio Status dialog box before
NOTE