User's Manual

and separated by a space; No HEX or CHARs. The 8 numbers represent the 8-byte Smartset
Command.
6.2.2 Smartset Command Limitations:
There is no limit to the number of Smartset commands that can be sent. For example, if 10
Smartset Commands (10 lines) are specified under the [Smartset Commands] section, all 10
Smartset Commands will be sent to the controller when the Elo's device driver is loaded.
6.2.3 Calibration on system with multiple monitors in spanned display mode
The “Span Mode” is a special video setup on a system with multiple monitors configured to
behave as a single big video surface “spanned” across all the monitors. The multiple monitors
can be consisted of Elo’s touch monitors with/without regular display monitors.
With span mode configured, the user must check “Spanned display mode” in the “Common
Settings” window before running calibration. Prior to calibration starting, a small window will
appear asking the user to provide the number of rows and columns of the spanned setup (For
example, if the spanned setup consist of three monitor placed side-by-side horizontally, the row
number is 1, and the column number is 3). After this information has been entered, calibration
will start.
6.2.4 Border touch warning for 2515-07
Elo driver will show a warning message which tells the user “Please remove any contact from
the monitor border area” if you touch and hold the border/side for about 2 seconds, put a sticky
note on the border, or squeeze the border. If you touch the border shortly and lightly, no warning
message will appear.
7. History of Changes
Release 3.0.1
• EloMtApi: pre-cal not committed to NVRam.
• USB driver: pivot test missing drawing segments
• EloConfig.exe: added command line parameter “/align” to allow video alignment.
Release 3.0.2
• Write NVRam is turned off by default (EloOptions.ini).
Release 4.0.1
• Support motherboard beep on Windows 7 (both 32-bit and 64-bit systems).
• Support optical touch screens: 0x202E-0x06 (dual-touch) and 0x04E7-0x80 (four-touches).
• Sending user defined Smartset commands (in EloOptions.ini) at system startup or driver loading.
• Utility to allow user to define touch enabled areas (EloTouchZones.exe).
• Position log files in “Elo Touch Systems” folder under “ProgramData”.
• During calibration, once a monitor is touched, the session should be completed on that monitor.
• Incorrect Windows Monitor number showed in Property page if the system has un-connected
video port.
• IT2701 sleep/resume fails about 20% of times.
• EloConfig unwanted popup at system startup.
• Support pCap touch screen 0xEEF-7200.