Specifications

Command Descriptions 87
3 2400
4 4800
5 9600
6 19200
7 38400
Serial controllers are shipped jumpered for 9600 baud. The values for the S1 byte
correspond to those used in the Parameter command (page 95). Not all of the
above baud rates are available through jumper settings.
The S2 byte is an ASCII '0' if serial Hardware Handshaking is disabled by the J3
jumper on power-on. It is a '1' if Hardware Handshaking is enabled. Serial
controllers are shipped jumpered for Hardware Handshaking enabled (J3 not
installed).
The S3 byte is an ASCII '0' if the SmartSet ASCII Mode is selected on power-on
by the J2 jumper. A '1' indicates the SmartSet Binary Mode. Serial controllers are
shipped jumpered for Binary Mode (J2 not installed).