Specifications

Sample Driver Code 59
return(0);
}
void displayjumpers(void)
{
int i;
packettype id,owner,jumpers;
printf("ID:\n");
id[0] = 'i'; querycommand(id);
owner[0] = 'o'; querycommand(owner);
printf(" Controller revision level: ");
for (i=1; i<8; i++)
printf("%c",owner[i]);
printf(" %d.%d\n",id[5],id[4]);
printf(" Z axis: ");
if (id[3] & 0x80)
printf("Available\n");
else
printf("Not available\n");
printf("Jumper settings:\n");
jumpers[0] = 'j'; querycommand(jumpers);
printf(" Touchscreen type: ");
switch(jumpers[1]) {
case '0': printf("AccuTouch\n"); break;
case '1': printf("DuraTouch\n"); break;
case '2': printf("IntelliTouch\n");
}
printf(" Interface: ");
switch(jumpers[2]) {
case '0': printf("Serial\n"); break;
case '1': printf("PC-Bus\n"); break;
case '2': printf("Micro Channel\n");
}
printf(" Boot from: ");
if (jumpers[3] == '0') printf("Jumpers\n");
else printf("NVRAM\n");
printf(" Mode: ");
if (jumpers[4] == '0') printf("Single Point\n");
else printf("Stream\n");
if (jumpers[2] == '0') { /* serial controller */
printf(" Hardware handshaking: ");
if (jumpers[6] == '1') printf("Enabled\n");
else printf("Disabled\n");
printf(" Output format: ");
if (jumpers[7] == '0') printf("ASCII\n");
else printf("Binary\n");
}
else {
printf(" Interrupt: %d\n", jumpers[5]);
printf(" Base address: %X\n", jumpers[6]+(jumpers[7] << 8));
}
}
#include "bus.c" /* for E271-2201 and E271-2202 */
/* #include "serial.c" */ /* for E271-2200 and E271-2210 */