Specifications

Running SMARTSET 37
Elo TouchSystems SmartSet(tm) Series Setup Utility Ver. 1.2
Select Interface Type
Serial
PC-Bus
Enter Base I/O Port address in hex ([Enter] accepts): 280
Current Jumper Settings
Screen type: AccuTouch
I/O: PC-Bus
Setup is by: Jumpers
Mode: Stream
Interrupt #: None
Base address: 280
Press any key to continue.
Idle
Figure 4-2. SmartSet Utility Jumper Settings Display
Press a key to display the Main Menu, shown below.
Elo TouchSystems SmartSet(tm) Series Setup Utility Ver. 1.2
Type: 2201/PC-Bus/AccuTouch ROM Revision: 1.2 Owner ID: EloInc.
ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
º Main Menu ³ Load/Save Setup º
ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
º L) Load/Save Setup ³ Data Direction: Save º
º ³ Data Source/Destination: To Disk º
º C) Communications ³ º
º M) Touch Mode ³ Setup º
º P) Touch Reporting ³ 2nd Calib/Scaling º
º B) Calibration ³ º
º S) Scaling ³ Program Controller º
º I) Timer ³ º
º F) Filter ³ º
º T) Touch Testing ³ º
º D) Diagnostics ³ º
º R) Reset Controller ³ º
º A) ASCII Setup ³ º
º ³ º
º X) Exit ³ º
ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ
Communication status: Communicating with controller.
Help-[F1]: Use -¯® to move cursor bar, [Enter] to select/modify.
Smartset is: Idle
Figure 4-3. SmartSet Utility Main Menu
The top of the screen shows the version of the SMARTSET program, the type of
controller and touchscreen, the ROM revision level of the controller firmware, and
the Owner ID string, factory set to "EloInc." unless you have a special OEM
configuration.
The bottom of the screen contains some status information which is updated after
each command. The Communication Status indicates if SMARTSET is
NOTE
A warning message is displayed if the controller is not detected. You may proceed
to the Main Menu and SMARTSET will assume default settings for all controller
parameters. You may then change any parameters and save all settings to a disk
file. This file can later be transferred to a connected controller. If you change the
communication parameters from the Main Menu, SMARTSET will attempt to
establish communication with the controller again.