Specifications

16 Chapter 2 - Controller Jumper Settings
Emulation Mode
If you are using driver software that does not directly support the SmartSet
protocol, the E271-2200 and E271-2210 controllers can be set up through jumpers
for hardware compatibility with the AccuTouch E271-140 controller, IntelliTouch
E281A-4002 controller (2.0 or later firmware), or the DuraTouch E261-280
controller.
When the controller is in an emulation mode, it will not respond to the SmartSet
protocol. For descriptions of the protocols in the various emulation modes, see
Appendix A.
As an alternative to full emulation modes, a software command may be used to
select a wide range of output data formats. The output data format can be saved in
NVRAM as a power-on default. See the Emulate command, page 80, for details.
To select an emulation mode, set the jumpers as follows:
Emulation Mode Jumpers
None (SmartSet Mode) J10-N (shipped setting)
J11-N
AccuTouch E271-140 J10-Y
J11-N
IntelliTouch E281A-4002 J10-N
(2.0 or later firmware) J11-Y
DuraTouch E261-280 J10-Y
J11-Y
When emulation mode is enabled, J2 selects ASCII or binary emulation in the
protocol specified by J10 and J11.
Reserved Jumpers
Jumpers J6, J8, and J9 on the E271-2200 and E271-2210 controllers are reserved.
They should not be installed.