User's Manual

User Guide – ELO-KIT-ECMG2-AND
UM600069 Rev A, Page 7 of 26
Connector Panel & Interfaces
Touchmonitor & Computer Module Connections
1. Once the Computer Module has been installed, connect the AC power cable between
the touchmonitor’s POWER IN connector and the AC power source.
NOTE: Computer Module can be installed when the AC power cable is connected (Hot
pluggable). Do not remove the computer module unless it is completely shut off.
2. Make any desired connections to the Computer Module connector panel.
3. Press the touchmonitor’s power button to turn on the Computer Module.