User's Manual

User Guide – ELO-KIT-ECMG2-AND
UM600069 Rev A, Page 15 of 26
 pullHighGPIO
 Pull high the state of GPIO-iface
 PullLowGPIO
 Pull low the state of GPIO-iface disactiveBCR
 getGPIOInterfaces
 Get the list string data of interest GPIOs at designed system.
 Refer to Table 3-1 GPIOs list
 Note:
 The pull action only workable with output pin defined GPIO
 The input pin defined GPIO can notify the application about the status change by
“ELOPeripheralEventListener” also
GPIOs
PIN define
gpio80
Output
gpio81
Input
gpio82
Input
Table 3-1 GPIOs List
3.1.3. IDLE
 activeIdleMode
 Force system to enter IDLE_MODE (IDLE_MODE on)
 disactiveIdleMode
 Force system to leave IDLE_MODE (IDLE_MODE off)
3.2. ELOPeripheralEventListener