User manual

User Manual– Interactive Digital Signage
SW601990 Rev A, Page 26 of 32
Chapter 7 – Technical Support
If you are experiencing trouble with your touchmonitor, refer to the following suggestions.
If the problem persists, please contact your local dealer or contact Elo Touch Solutions Customer
Service.
Solutions to Common Problems
Problem Suggested Troubleshooting
The touchmonitor does not respond when
turning on the system.
Check that the AC power cable is properly
connected.
Verify the AC power source is functioning.
The Computer Module does not respond
when turning on the system.
Disconnect the AC power cable and verify that the
Computer Module is properly installed. Reconnect
the AC power cable.
Monitor display is dim.
Use the OSD to increase the brightness.
Use the OSD to increase the contrast.
Monitor display is blank.
If the Power Status LED is blinking, the monitor or
Computer Module may be in SLEEP mode. Press
any key / move the mouse / touch the touchscreen to
see if the image reappears.
Monitor displays an “Out Of Range”
message.
Adjust your computers resolution/timing mode to be
within the allowable timing ranges specified for your
touchmonitor on the Elo website www.elotouch.com.
Touch functionality doesn’t work.
Verify your computer or Elo Computer Module has
the latest drivers installed. Refer to the Setup
chapters for details.
Technical Assistance
Visit www.elotouch.com/go/websupport for online self-help.
Visit www.elotouch.com/go/contactsupport for technical support.
See this user manuals last page for worldwide technical support phone numbers.
Technical assistance for the Computer Module with Windows OS is also available on the computer in
the Support Information section of the Systems Properties menu. The Systems Properties menu can
be accessed by:
1. Right-clicking the My Computer icon and selecting Properties from the drop-down menu, or
2. Click the Start button; go to the Settings -> Control Panel menu and selecting the System icon