User manual

User Manual– Interactive Digital Signage
SW601990 Rev A, Page 16 of 32
Chapter 6 – Operation
Power
To turn the touchmonitor on or off, press the touchmonitor power button once. If a computer
module is installed into the monitor, then the computer module will also turn on with the monitor.
To abruptly power off the Computer Module and touchmonitor, press and hold the touchmonitor
power button until the computer shuts off.
To gracefully shut down the computer module, follow the Computer Modules operating systems
normal power off procedure.
A Power Status LED is provided on the OSD Remote that functions according to the following
table:
Touchmonitor/Computer Module status LED status
OFF OFF
SLEEP BLINKING
ON ON
The system consumes low power when in SLEEP and OFF modes. For detailed power
consumption specifications, refer to technical specifications available on the Elo website
www.elotouch.com.
Touching the screen will bring the system out of SLEEP mode (similar to moving the mouse or
pressing a keyboard key).
If long periods of disuse are planned, unplug the AC power cable to save power.
The power ratings for the IDS 01 Series monitors are:
ET3201L / ET4201L 100-240 Vac, 50/60 Hz, 3.6-1.5 A
ET7001L 100-240 Vac, 50/60 Hz, 5-2.1 A