Installation Guide Manual

Trombone Installation Guide Installation
MAN-TROIG (Ver. 1.403)
www.elmomc.com
16
Chapter 3:
Installation
The Trombone must be installed in a suitable environment and properly connected to its
voltage supplies and the motor.
3.1. Site Requirements
You can guarantee the safe operation of the Trombone by ensuring that it is installed in an
appropriate environment.
Feature Value
Ambient operating temperature
0 °C to 40 °C (32 °F to 104 °F)
Maximum non-condensing humidity 90%
Operating area atmosphere No flammable gases or vapors permitted in
area
Models for extended environmental conditions are available.
Caution:
The Trombone dissipates its heat by convection. The maximum ambient
operating temperature of 40 °C (104 °F) must not be exceeded.
3.2. Unpacking the Drive Components
Before you begin working with the Trombone, verify that you have all of its components, as
follows:
• The Trombone servo drive
• The Composer software and software manual
The Trombone is shipped in a cardboard box with Styrofoam protection.
To unpack the Trombone
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.