Owner's manual

Cymbal Installation Guide Safety Information
MAN-CYMIG (Ver. 1.3)
7
1.1. Warnings
• Toavoidelectricarcingandhazardstopersonnelandelectricalcontacts,never
connect/disconnecttheservodrivewhilethepowersourceison.
• Powercablescancarryahighvoltage,evenwhenthemotorisnotinmotion.Disconnect
theCymbalfromallvoltagesourcesbeforeitisopenedforservicing.
• TheCymbalservodrivescontaingroundingconduitsforelectriccurrentprotection.Any
disruptiontotheseconduitsmaycausetheinstrumenttobecomehot(live)anddangerous. 
• Aftershuttingoffthepow erandremovingthepowersourcefromyourequipment,wait at
least1minutebeforetouchingordisconnectingpartsoftheequipmentthatarenormally
loadedwithelectricalcharges(suchascapacitorsorcontacts).Measuringtheelectrical
contactpointswithameter,beforetouchingtheequipment,isrecommended.
1.2. Cautions
• TheCymbalservodrivescontainhotsurfacesandelectrically‐chargedcomponentsduring
operation.
• ThemaximumDCpowersupplyconnectedtotheinstrumentmustcomplywiththe
parametersoutlinedinthisguide.
• WhenconnectingtheCymbaltoanapproved12to95VDCauxiliarypowersupply,connect
itthroughalinethatisseparatedfromhazardouslivevoltagesusingreinforcedordouble
insulationinaccordancewithapprovedsafetystandards.
• BeforeswitchingontheCymbal,verifythatallsafetyprecautionshavebeenobservedand
thattheinstallationproceduresinthismanualhavebeenfollowed.
www.elmomc.com