Owner's manual

Cymbal Installation Guide Installation
MAN-CYMIG (Ver. 1.3)
26
Pin

Signal Function Description PinLocation
12 ECLP External
currentlimit
peak
Externalvoltagescalesdownthe
ratedvalue.
Voltagerange:0Vto3.75V(3.75V
=ratedIp)
13 ECLC External
currentlimit
continuous
Externalvoltagescalesdownthe
ratedvalue.
Voltagerange:0Vto3.75V(3.75V
=ratedIc)
14 EN+ Enable+ Positivevoltageinput ofthe
“AmplifierEnable”function.
Toenableoperationofthe
amplifier,theoptocouplermustbe
energizedbyapplyingvoltage
betweenthispin(+)andpinJ2/15
(‐).
Theoptocouplerisisolatedfrom
theamplifier.
“OFF”voltage:0V<Vin<1V.
“ON”voltage:2.5V<Vin<10V,
5Vtypicallywithcurrent
consumption2.5mA.
15 EN‐ Enable‐ Negativevoltageinputof
“AmplifierEnable”function.
Optocouplerisisolatedfromthe
amplifier.
Fordetails,seepinJ2/14.
Table7:J2,ControlConnectorCable‐PinAssignments
Note: AlloftheXXRETsareshortedinternally.
www.elmomc.com