Owner's manual

Table Of Contents

Cymbal Installation Guide Installation

MAN-CYMIG (Ver. 1.3)

3.5.2. Control,I/OsandHallsCableAssemblies

TheCymbalfeatureseasy‐to‐useD‐SubtypeconnectionsforallControl,I/Osandhallscables.

Belowareinstructionsanddiagramsdescribinghowtoassemblethesecables.

• Use24,26or28AWGtwisted‐pairshieldedcables(24AWGcableisrecommended).For

bestresults,theshieldshouldhavealuminumfoilcoveredbycopperbraid.

• UseonlyaD‐Subconnectorwithametalhousing.

• AttachthebraidshieldtightlytothemetalhousingoftheD‐typeconnector.

• Onthemotorsideconnections,groundtheshieldtothemotorchassis.

• Oncontrollersideconnections,followthecontrollermanufacturer’srecommendations 

concerningtheshield.





Figure10:Control,I/OsandHallsCableAssemblies

Note: AllD‐Subtypeconnectors,usedwiththeCymbal,shouldbeassembledinthisway.



MetalHousing

Makesurethatthebraidshieldisintight

contactwiththemetalhousing