User Manual

Gold Bell Installation Guide Safety Information

MAN-G-BELIG (Ver. 1.004)

www.elmomc.com

1.1. Warnings

• To avoid electric arcing and hazards to personnel and electrical contacts, never

connect/disconnect the servo drive while the power source is on.

• Power cables can carry a high voltage, even when the motor is not in motion. Disconnect

the Gold Bell from all voltage sources before it is opened for servicing.

• The Gold Bell servo drive contains grounding conduits for electric current protection. Any

disruption to these conduits may cause the instrument to become hot (live) and dangerous.

• After shutting off the power and removing the power source from your equipment, wait at

least 1 minute before touching or disconnecting parts of the equipment that are normally

loaded with electrical charges (such as capacitors or contacts). Measuring the electrical

contact points with a meter, before touching the equipment, is recommended.

1.2. Cautions

• The Gold Bell servo drive contains hot surfaces and electrically-charged components during

operation.

• The maximum DC power supply connected to the instrument must comply with the

parameters outlined in this guide.

• When connecting the Gold Bell to an approved isolated 12–95 VDC auxiliary power supply,

connect it through a line that is separated from hazardous live voltages using reinforced or

double insulation in accordance with approved safety standards.

• Before switching on the Gold Bell, verify that all safety precautions have been observed

and that the installation procedures in this manual have been followed.

• Do not clean any of the Gold Bell drive's soldering with solvent cleaning fluids of pH greater

than 7 (8 to 14). The solvent corrodes the plastic cover causing cracks and eventual damage

to the drive's PCBs.

Elmo recommends using the cleaning fluid Vigon-EFM which is pH Neutral (7).

For further technical information on this recommended cleaning fluid, select the link:

http://www.zestron.com/fileadmin/zestron.com-usa/daten/electronics/Product_TI1s/TI1-

VIGON_EFM-US.pdf