Instruction Manual
Table Of Contents
- Chapter 1: Safety Information
- Chapter 2: Product Description
- 2.1. Functional Description
- 2.2. Product Features
- 2.2.1. High Power Density
- 2.2.2. Supply Input
- 2.2.3. Servo Control
- 2.2.4. Advanced Filters and Gain Scheduling
- 2.2.5. Motion Control
- 2.2.6. Fully Programmable
- 2.2.7. Feedback Ports Options
- 2.2.8. Feedback Sensor Specifications
- 2.2.9. Communications
- 2.2.10. Safety
- 2.2.11. Outputs
- 2.2.12. Inputs
- 2.2.13. Built-In Protection
- 2.2.14. Status Indication
- 2.2.15. Automatic Procedures
- 2.3. System Architecture
- 2.4. How to Use this Guide
- Chapter 3: Technical Information
- Chapter 4: Installation
- 4.1. Site Requirements
- 4.2. Unpacking the Drive Components
- 4.3. Connectors
- 4.4. Mounting the Gold Hawk
- 4.5. Integrating the Gold Hawk on a PCB
- 4.6. The Gold Hawk Connection Diagram
- 4.7. Main Power, Auxiliary Power and Motor Power
- 4.8. STO (Safe Torque Off) Inputs
- 4.9. Feedback
- 4.10. User I/Os
- 4.11. Communications
- 4.12. Powering Up
- 4.13. Initializing the System
- 4.14. Heat Dissipation
- Chapter 5: Technical Specifications
- Chapter 6: Gold Line Standards
Gold Hawk Installation Guide Technical Specifications
MAN-G-HAKIG (Ver. 1.001)
www.elmomc.com
82
5.5. Safe Torque Off (STO)
The Gold Hawk has two STO (Safe Torque Off) inputs.
5.5.1. STO Input Interfaces – TTL Mode
Feature Details
Type of input Optically isolated
Input current for all inputs Iin = 3.8 mA @ Vin = 5 V
High-level input voltage 2.4 V < Vin < 15 V, 5 V typical
Low-level input voltage 0 V < Vin < 0.8 V
Minimum pulse width >3 ms
Figure 42: STO Input Schematic
5.6. Communications
Specification Details
RS-232
Signals:
• RS232_Rx, RS232_Tx COMRET
• Full duplex, serial communication for setup and control
• Baud Rate of 9,600 to 57,600 bit/sec
Electrical Characteristic
Min
Type
Max
Unit
V
IH
High-level input voltage
2
3.3
V
V
IL
Low-level input voltage
0.8
V
V
OH
High-level output voltage
2.4
V
V
OL
Low-level output voltage
0.4
V
CAN
CAN bus Signals:
• CAN_H, CAN_L, CAN_RET
• Maximum Baud Rate of 1 Mbit/sec.
Version:
• DS 301 v4.01