Instruction Manual
Table Of Contents
- Chapter 1: Safety Information
- Chapter 2: Product Description
- 2.1. Functional Description
- 2.2. Product Features
- 2.2.1. High Power Density
- 2.2.2. Supply Input
- 2.2.3. Servo Control
- 2.2.4. Advanced Filters and Gain Scheduling
- 2.2.5. Motion Control
- 2.2.6. Fully Programmable
- 2.2.7. Feedback Ports Options
- 2.2.8. Feedback Sensor Specifications
- 2.2.9. Communications
- 2.2.10. Safety
- 2.2.11. Outputs
- 2.2.12. Inputs
- 2.2.13. Built-In Protection
- 2.2.14. Status Indication
- 2.2.15. Automatic Procedures
- 2.3. System Architecture
- 2.4. How to Use this Guide
- Chapter 3: Technical Information
- Chapter 4: Installation
- 4.1. Site Requirements
- 4.2. Unpacking the Drive Components
- 4.3. Connectors
- 4.4. Mounting the Gold Hawk
- 4.5. Integrating the Gold Hawk on a PCB
- 4.6. The Gold Hawk Connection Diagram
- 4.7. Main Power, Auxiliary Power and Motor Power
- 4.8. STO (Safe Torque Off) Inputs
- 4.9. Feedback
- 4.10. User I/Os
- 4.11. Communications
- 4.12. Powering Up
- 4.13. Initializing the System
- 4.14. Heat Dissipation
- Chapter 5: Technical Specifications
- Chapter 6: Gold Line Standards
Gold Hawk Installation Guide Installation
MAN-G-HAKIG (Ver. 1.001)
www.elmomc.com
53
Pin (J2) Signal Function
2 PortC_ENCO_A- Buffered Channel A- output/Pulse-/PWM-
4 PortC_ENCO_A+ Buffered Channel A+ output / Pulse+/PWM+
6 PortC_ENCO_B- Buffered Channel B- output / Dir-
8 PortC_ENCO_B+ Buffered Channel B+ output / Dir+
10 PortC_ENCO_INDEX- Buffered Channel INDEX- output
12 PortC_ENCO_INDEX+ Buffered Channel INDEX+ output
Table 14: Port C Pin Assignment
Figure 24: Emulated Encoder Differential Output – Recommended Connection Diagram
4.9.4. Analog Input
An analog user input can be configured by software to be used as either tachometer velocity
sensor input or potentiometer position feedback. For connection diagrams refer to
Section 4.10.3.