Instruction Manual
Table Of Contents
- Chapter 1: Safety Information
- Chapter 2: Product Description
- 2.1. Functional Description
- 2.2. Product Features
- 2.2.1. High Power Density
- 2.2.2. Supply Input
- 2.2.3. Servo Control
- 2.2.4. Advanced Filters and Gain Scheduling
- 2.2.5. Motion Control
- 2.2.6. Fully Programmable
- 2.2.7. Feedback Ports Options
- 2.2.8. Feedback Sensor Specifications
- 2.2.9. Communications
- 2.2.10. Safety
- 2.2.11. Outputs
- 2.2.12. Inputs
- 2.2.13. Built-In Protection
- 2.2.14. Status Indication
- 2.2.15. Automatic Procedures
- 2.3. System Architecture
- 2.4. How to Use this Guide
- Chapter 3: Technical Information
- Chapter 4: Installation
- 4.1. Site Requirements
- 4.2. Unpacking the Drive Components
- 4.3. Connectors
- 4.4. Mounting the Gold Hawk
- 4.5. Integrating the Gold Hawk on a PCB
- 4.6. The Gold Hawk Connection Diagram
- 4.7. Main Power, Auxiliary Power and Motor Power
- 4.8. STO (Safe Torque Off) Inputs
- 4.9. Feedback
- 4.10. User I/Os
- 4.11. Communications
- 4.12. Powering Up
- 4.13. Initializing the System
- 4.14. Heat Dissipation
- Chapter 5: Technical Specifications
- Chapter 6: Gold Line Standards
Gold Hawk Installation Guide Installation
MAN-G-HAKIG (Ver. 1.001)
www.elmomc.com
27
Pin (J2) Signal Function
10 PortC_ENCO_INDEX- Port C - index complement output
11 PortA_ENC_INDEX- Port A - index complement
12 PortC_ENCO_INDEX+ Port C - index output
13 PortB_ENC_A+/SIN+ Port B - channel A
14 HC Hall sensor C input
15 PortB_ENC_A-/SIN- Port B - channel A complement
16 HB Hall sensor B input
17 PortB_ENC_B+/COS+ Port B - channel B
18 HA Hall sensor A input
19 PortB_ENC_B-/COS- Port B - channel B complement
20 ANARET Analog return
21 PortB_ENC_INDEX+/ANALOG_I+ Port B – index
RESOLVER_OUT+ Vref
22 ANALOG1+ Analog input 1
23 PortB_ENC_INDEX-/ANALOG_I- Port B – index complement
RESOLVER_OUT- Vref complement
24 ANALOG1- Analog input 1 complement
25 COMRET Common return
26 +3.3V 3.3 V supply voltage for EtherCAT LEDs
Note: The pin connector should only be
used for the 3.3V EtherCAT LED and
EtherCAT RJ-45.
27 PHY_IN_RX+ EtherCAT In receive
28 EtherCAT: PHY_OUT_RX+ EtherCAT Out receive
CAN: Reserved Reserved
29 PHY_IN_RX- EtherCAT In receive complement
30 PHY_OUT_RX- EtherCAT Out receive complement
31 COMRET Common return
32 COMRET Common return
33 PHY_IN_TX+ EtherCAT In transmit