Owner's manual

Panther Installation Guide Installation
MAN-PANIG (Ver. 1.302)
www.elmomc.com
23
3.4. Mounting the Panther
The Panther (Figure 2) is designed for mounting on a printed circuit board (PCB). It is connected
by 2 mm pitch 0.51 mm square pins and 2.54 mm pitch 0.64 mm square pins. When integrating
the Panther into a PCB, be sure to leave about 1 cm (0.4") outward from the heat sink to enable
free convection of the air around the Panther. We recommend that the Panther be soldered
directly to the board. If the PCB is enclosed in a metal chassis, we recommend that the Panther
be screw-mounted to it as well to help with heat dissipation. The Panther has screw-mount
holes on each corner of the heat sink for this purpose.
All dimensions are in mm.
Figure 2: Panther Dimensions