Owner's manual

Cornet Installation Guide Installation

MAN-CORIG (Ver. 1.502)

www.elmomc.com

1.13.8.3. Digital Outputs (on the GENERAL I/O Port)

The Cornet servo drive has a 15-pin, high-density, D-Sub socket for digital outputs. When

assembling an I/O cable for digital outputs, follow the instructions in Section 1.13.4 (Feedback

and Control Cable Assemblies) using a 15-pin D-Sub plug with a metal case. The pins are

described below.

Pin Signal Function Pin Positions

1 OUT1 Programmable output 1

2 OUT2 Programmable output 2

3 OUT3 Programmable output 3

4 OUT4 Programmable output 4

5 OUT5 Programmable output 5

6 OUTRET1 Programmable output return 1

7 OUTRET2 Programmable output return 2

8 OUTRET3 Programmable output return 3

9 OUTRET4 Programmable output return 4

10 OUTRET5 Programmable output return 5

11 OUT6 Programmable output 6

12 OUTRET6 Programmable output return 6

13 - -

14 - -

15 - -

Table 13: Digital Outputs (on the General I/O port) Cable - Pin Assignments