- DBP SERIES USER MANUAL

DBP - Rev 6/93

9. Tables and Summaries

9.1 Display diagnostics

Each amplifier's fault is stored immediately in the DCB RAM. In addition to

that, a Failure Message is displayed. Following are all the valid Display

Messages:

Event Display Display

after

Recurring

DIP switch 1 - ON BAUD OK

Load is under cont. current limit CLIM C-OK

Battery Low BATT B-OK

Abort condition (hardware only) ABRT A-OK

Amplifier's power stage disabled

AMPD H-OK

-15V out of limits -15V F-OK

Under or Over Voltage VOLT F-OK

+15V out of limits +15V F-OK

Over Temperature TEMP F-OK

Commutation problem (for brushless drives

only)

CMMT F-OK

Short condition at the power outputs SHRT F-OK

The AMPD message appears in two cases:

1. When MO (Motor Off) command is given.

2. Position error exceeds the allowed value.