Manualshelf

Operating instructions

ManualsBrandsElmo ManualsSecurity CameraPTC-100S
1234567
Page 7
6 Leighton Place
Mahwah, New Jersey 07430
P: 201•848•9818 F: 201•848•9819
SONY EVI-D100 OWNERS PLEASE READ!
To use the Sony EVI-D100 camera with the Telemetrics CP-ITV4-S3-Axis ITV Control Panel, the EVI-D100 must be set to
work in EVI-D70 mode. You must place the EVI-D100 into EVI-D30 emulation mode. A switch is located on the bottom of
the EVI-D100 to set the emulation mode. Please refer to the EVI-D100 manual.
Please make sure that the baud rate for the camera is 9600 baud.
SONY EVI-D70 OWNER PLEASE READ!
To use the Sony EVI-D70 camera with the Telemetrics CP-ITV4-S 3-Axis ITV Control Panel, the EVI-D70 must be set to
work in EVI-D30 mode. You must place the EVI-D70 into EVI-D30 emulation mode. A switch is located on the bottom of
the EVI-D70 to set the emulation mode.
The baud rate for the camera must be 9600 baud. Please refer to the EVI-D70 manual.
Customers using the CP-ITV-D100 (purchased prior to February 2004) with firmware versions 53355 016 REV F and
lower may notice a communications lag between the control panel and Sony EVI-D70. The firmware can be identified by
removing the bottom cover of the CP-ITV-D100. To get the best performance from your CP-ITV-D100, please contact
Telemetrics Inc. for an updated firmware.
SONY EVI-D30 OWNERS PLEASE READ!
The Telemetrics CP-ITV4-S 3-Axis ITV Control Panel operates the EVI-D30 camera directly.
Please make sure that the baud rate for the camera is 9600 baud
.
ELMO PTC-100 OWNERS PLEASE READ!
The Telemetrics CP-ITV4-S 3-Axis ITV Control Panel operates the Elmo PTC-100 camera directly for serial number
101426 and higher. All other PTC-100 please contact Telemetrics Inc. for the correct firmware. The older PTC-100 did
not correctly employ variable control of pan and tilt.
Please make sure that the baud rate for the camera is 9600 baud
.
SONY EVI-HD3V OWNERS PLEASE READ!
To use the SONY EVI-HD3V with the Telemetrics CP-ITV4-S 3-Axis ITV Control Panel, the SONY EVI-HD3V must be set
to 9600 baud (DIP Switch on bottom). Please, refer to camera manual.