Operating instructions

Page 4
6 Leighton Place
Mahwah, New Jersey 07430
P: 201•848•9818 F: 201•848•9819

The LOC/REM allows for control of a remote camera system. The local/remote function can only be used in
systems using the daisy chain connection. This feature allows a remote serial device connected to port 4 of the
ITV control panel to gain control of the cameras connected to the ITV panel. The remote device can be another
CP-ITV control panel, computer, or other control source (AMX, Crestron, etc.)
When the LOC/REM button on the remote panel is pressed, the LED will turn green indicating that you have
remote control of the cameras connected to the local panel. The LOC/REM button on the local panel will be
flashing indicating that a remote device has control of the local cameras. The local panel can regain control of
the cameras by pressing the LOC/REM button. The button will go out on both panels, indicating that the local
panel has control of the local cameras, and the remote panel does not.
If both control panels have cameras attached to the panel, either panel can remotely control cameras. It is not
possible to remotely control each others cameras simultaneously.
NOTE: Gaining control of remote cameras may not happen on the first key press. The local panel will only give
up control when no operation or communication is taking place. Another key press may be required until control is
taken.
CP-ITV4-S
PO RT 1
System with Home Run Wirin
g
Control Cable
*Extension Cable (Optional)
25’ CA-ITV-D-25
50’ CA-ITV-D-50
100’ CA-ITV-D-100
200’ CA-ITV-D-200
300’ CA-ITV-D-300
400’ CA-ITV-D-400
500’ CA-ITV-D-500
6’ CA-ITV-DIN-6
25’ CA-ITV-DIN-25
* Remote Panel only
available with daisy
chain configuration
* For Plenum cables, use part number CA-ITV-DP-XXX (where XXX=feet).
PO R T 2 PO RT 3 P O RT 4

Connect power, camera data cables to rear panel. The port marked 1 is the output for the EVI-D100 CAMERA 1.
The port marked 2 is the output for the EVI-D100 CAMERA 2. The port marked 3 is the output for the EVI-D100
CAMERA 3. The port marked 4 is the output for the EVI-D100 CAMERA 4. TURN THE CONTROL PANEL ON
LAST.

Select CAMERA to be controlled by momentarily pressing the proper button (1 through 4). If a camera is not
present, the LED will blink for 4 seconds. To select another camera press any of the other camera selects.

Operate PAN-TILT-ZOOM-FOCUS controls to obtain image desired. To operate focus, use the FR to focus a far
object and the NR to focus a near object. If focus control is activated, the focus function will automatically switch
from auto to manual to allow for manual focus control. To return to auto focus, depress the FOCUS AUTO/MAN
button. To operate zoom rotate the joystick knob. Turn counterclockwise for wide view and clockwise for
telephoto view. To operate the PAN and TILT movement, use the joystick. Up and down is the TILT axis; and left
and right is the PAN axis.