User manual

Note

Sensitivity will remain the same for all de-

tection areas on the selected channel.

Set Refresh time. Refreshing an image more often will decrease the cumulative image difference caused by normal

occurrences, such as changing illumination across the period of a day and will reduce the number of false alarms.

Note

Refresh time will remain the same for all

detection areas on the selected channel.

1.3.17.2. Creating Intelli-Zone™ detection area(s):

To create Intelli-Zone™ detection area(s), do the following:

1. Place the cursor over the start point on the live view window

2. Hold the left mouse button down and drag to create a rectangular area

3. Let the mouse button go

4. Move/adjust the area if necessary

5. To delete a target area, click the area to select it, hold the left mouse button down and drag the detection area off

from the live view window

To erase all created areas, click Reset All Areas

1.3.17.3. Configuring Intelli-Zone™ detection area(s):

Each detection area has its own configuration and has to be saved individually. Up to 10 detection areas can be configured.

Each detection area can have its unique set of settings, including Area Name, Go to Preset #, Percent of Change, Dwell

Time, Control output, and Associated Channel. To switch between detection areas, select the chosen detection area by

clicking on the desired green box in the live view window. Selected detection area will be highlighted in red.

1. Select the specific detection area by clicking it in the live view window. Selected detection area is highlighted in red.

Enter Area Name for the created target zone in the Detection Zone frame. In the example above, the

detection area has been labeled "area1".

Select Go to Preset #. This is the position the PTZ camera will move to after the motion has been detected in

the selected detection area. Click the Browse button to select the desired preset from the list. All presets

are configured in the PTZ Mode. (Please see Programming Presets section for more information). In the example

above, Channel #1 will move to Preset 3 when motion is detected on area1.

Set the Percent of Change between 1% and 99%. This value determines the amount of change that has to

occur in the image in order to be recognized. In the example above, the image change has to be at least 10% in order

to be recognized by Intelli-Zone.

Caution

Lower values may cause false alarms.

Enter the Dwell Time (sec) (5-99 seconds). Dwell Time defines the number of seconds the selected channel

will remain in the Go to Preset position before returning to the Start Position. This Dwell Time also applies to the

Control output. In the example above, Channel #1 will remain in Preset 3 for 5 seconds before returning to Preset 1.

Control Output will remain active for 5 seconds after the motion has been detected on area1.

Assign the Control Output that will be triggered after the motion has been detected in the selected detection

area. Click the Browse button to select the desired control from the list. Only controls activated in the

79ELMO-PRO v.1.403.16 - User Manual

Intelli-Zone™ SetupChapter 1. ELMO-PRO Server

XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/