User manual

1.1.6. Setting up ELMO-PRO
Before powering up the ELMO-PRO, make sure that the switch in the rear of the DVR is set to 110/115V in North
America, 210/220V in other countries.
Warning
An uninterruptible power supply MUST be
used; otherwise all warranties will be
voided.
• Ground yourself
• Plug in the mouse and keyboard
• Plug in the VGA cable
• Plug in all the BNC connectors
• Plug in the power cable into the UPS (Uninterrupted Power Supply)
• Power up the system
Step 1: Plug the mouse and keyboard into the appropriate ports. The Mouse into the USB
port. The Keyboard port is color-coded Purple.
Step 2: Plug the monitor cable into the SVGA connector on the motherboard
Step 3: After grounding yourself, begin connecting your BNC video cables to the Server's
BNC ports. Make sure they are secure and locked into position. Once completed, make sure that
the dip switches are in the upward position. This is required in order to terminate the video signals.
The dip switch terminal is located below the video in/output.
Step 4: Connect the power cable to the power supply on your DVR.
4ELMO-PRO v.1.403.16 - User Manual
Setting up ELMO-PROChapter 1. ELMO-PRO Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/