User manual

b. Hold down the left mouse button and drag the cursor to draw the rectangular detection area
c. Let the mouse button go
d. Adjust or move the created detection area if necessary
4.
Click Area Draw to set the entire channel screen for motion detection
5.
Click Area Clear to reset all detection area on a selected channel
6. To delete a specific detection area, select the area by clicking on it, hold down the left mouse button and drag the
area to remove it from the live view screen.
7.
Click the Save button to save the configured settings
1.3.14.4. Configuring Intelli-Guard™ detection area(s):
To configure selected Intelli-Guard™ detection area, do the following:
1. Select desired detection area in the live view window. Settings for the selected detection zone will be displayed in
the Area No. frame.
2. Enter a descriptive name for the selected detection area in the Area Name: field. In the example below, Area No. 1
is called "warehouse".
3.
Check Send E-Mail checkbox to have an emergency Email sent every time an alarm is triggered in this Area.
The email address is taken from the Email Setup tab. Make sure to configure E-Mail setup tab.
4.
Check Control checkbox to activate selected control every time an alarm is triggered in this Area.
5.
Click the Browse button to select the desired control from the list. Only controls activated in the Hardware
Setup tab will be displayed.
6.
Set the working [Time] for the selected control. After the control has been activated, it will remain on for the set
period of time. In the example above, Control 1 will remain on for 5 seconds after the motion has been detected in
the Area No. 1.
72ELMO-PRO v.1.403.16 - User Manual
Intelli-Guard™ SetupChapter 1. ELMO-PRO Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/