User manual

•
Click Area Draw to set the entire channel screen for motion detection. Click Area Clear to reset all motion
detection zones on a specified channel
3. Select the desired motion detection area on the live view screen to activate the area settings. The selected area is
highlighted in red. If the entire channel screen is configured for motion detection, click inside the live view screen to
activate area settings.
Note
The area settings are configured individually
for each motion detection area.
4.
Set the Sensitivity for the selected motion detection zone. The higher the Sensitivity, the less change in an image
is needed to set off the alarm. If the Sensitivity is set to Low, the change in an image will have to be dramatic to be
detected as motion. This function only works properly indoors. The natural changes an outdoor environment (e.g.
clouds) can cause false alarms.
5.
Check the Alarm checkbox to enable the internal speaker alarm for selected motion detection zone
6. Set the Alarm active time. If motion is detected outside of the active time, the Alarm will not go off. In this example,
the Alarm is active from 7:30AM to 8:20PM on Area No. 1 on Channel 1.
7.
Check the Control checkbox to enable a control association for the selected motion detection area.
8. Choose the control number to be associated with the motion detected in the selected motion detection area. In the
example above, Control 2 will be activated if motion is detected in the Area No. 1 on Channel 1.
9.
Set the [Time] for the Control feature. This is the length of time that the control will stay on, if activated by motion
detection. In the example above, the Control 2 will stay on for 5 seconds if motion is detected on Area No. 1 on
Channel 1.
10.
Click the Save button to save the configured settings
Full Screen on motion function
ELMO-PRO software allows displaying selected video channel in the full screen mode every time motion is detected on
the configured motion detection zone.
Tip
To activate Full Screen Settings, the motion
detection has to be drawn and selected in
the live view window.
To configure the full screen function, do the following:
1. Draw and select the desired motion detection area on the live view screen
2.
Check Enable Full Screen checkbox to enable the full screen on motion function for the selected area
3.
In the Full Screen Channel drop-down menu choose the video channel to be displayed in full-screen mode
when motion is detected on the selected motion detection area
4.
Set the Dwell Time (sec) for the Full Screen Channel function. In the example above, Channel 1 will remain in
Full Screen mode for 5 seconds, after motion has been detected in the Area No. 1 on Channel 1.
5.
Click the Save button to save the configured settings
35ELMO-PRO v.1.403.16 - User Manual
Motion SetupChapter 1. ELMO-PRO Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/