User manual

3.
Click the NC/NO to set the sensors to NC (Normal Closed) or NO (Normal Open) depending on the type of the
sensor
4.
Assign a Linked Channel to the desired sensors. Click the Browse button to select the desired
channel from the list. If the specific sensor is triggered, the selected channel will begin recording. In the above example,
if Sensor 1 is triggered, Channel 1 (Front Door) will start recording.
Caution
Schedule Setup must be properly configured
for sensor recording.
5.
Assign a Linked Control to the desired sensors. Click the Browse button to select the desired control
from the list. If a specific sensor is triggered outside of the Control Active Time, the selected control is activated. In
the above example, if Sensor 1 is triggered, Control 1 (Open the door) will be activated.
6.
Choose Enable to have the alarm sound every time the sensor is triggered
OR
Choose Disable to disable the alarm
7.
Set the S/M Recording Time. The DVR will record for the number of seconds specified prior to and after the sensor
is triggered or the motion is detected. In this example, the video channel(s) will record for 10 seconds prior to the
sensor activation or motion detection and for 10 seconds after the sensor activation or after the motion has stopped.
The pre- and post-record length cannot exceed 10 seconds.
8.
Click the Save button to save the configured settings
Caution
Motion and Schedule Setups must be prop-
erly configured for sensor and/or motion
recording.
Related Topics: Hardware Setup-Channel Settings | Hardware Setup-Control Settings | Schedule Setup | Com-
munication Setup | Server Info | System Setup | Email Setup | Video Setup
1.3.4. Hardware Setup - External Monitor Setup
Important
Only Administrator User, elmo, has permis-
sion to configure this setup.
Tip
Hardware Setup tab can be hidden from all
other users in User Management setup tab.
1.3.4.1. Overview
The External Monitor section allows the user to view selected video inputs on an external monitor (if available). The ex-
ternal monitor should be connected to the DVR I/O Board. Video inputs will be displayed one-by-one in a sequence with
a configured delay time.
1.3.4.2. Creating or Modifying External Monitor Settings
Before configuring this section, make sure that the external monitor is properly connected to the DVR.
32ELMO-PRO v.1.403.16 - User Manual
Hardware Setup - External Monitor SetupChapter 1. ELMO-PRO Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/