User manual

There are three ways to send an email alert:
1.
Triggered Sensor(s)
Select appropriate sensors in the Enable Email For Sensor frame. Whenever any of the selected sensors
are triggered, an e-mail alert will be sent to the configured e-mail address.
Tip
Make sure the sensors are enabled and
configured in the Hardware Setup.
2.
Video Loss
Check the Video Loss checkbox in the Enable Email for Video Loss frame. When video loss is detected on one
or more channels, an e-mail alert will be sent to the configured e-mail address.
3.
Scheduled Server Status
This section allows the user to configure scheduled e-mails to provide the server status. The email includes a snapshot
from the specified channel. To have the DVR send server status e-mails, fill in Server Status section:
a.
Check the Send Email checkbox to enable server status e-mail alerts
b.
Select the frequency of the automatic e-mails (1-24 hours) in the Send Email Every field. In the example
above, the server status email will be sent out every hour.
100ELMO-PRO v.1.403.16 - User Manual
E-Mail SetupChapter 1. ELMO-PRO Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/