Security Camera User Manual

to “SP” and press <ENTER>

11. ALARM SETTING

Alarm parameters can be set on this page.

ALARM PIN

Choose an alarm connector what you want to set its status.

ALARM SWITCH

Turn ON/ OFF alarm function.

ALARM TYPE

There are two kind of alarm types can be selected. One is normal open the other is

normal close.

ALARM ACTION

User can choose what kind of action should be executed when the alarm condition

taken place. There are two kind of alarm actions can be set. One is go to a specific

position when alarm taken place. The other is executing sequence function when

alarm condition taken place.

Point Mode

PRESET POS.

Enter a preset position where the dome will go to when alarm pin is triggered.

Sequence Mode

SEQUENCE

Enter the sequence line you wish the Dome execute when alarm pin is

triggered.

DWELL TIME (Seconds)

Camera will stay at the preset position for “DWELL TIME” seconds then go back to

previous position. If you select “Always”, dome will go to the preset position and stay

there until alarm condition is released or user move its joystick on keyboard.

EXIT

Quit the ALARM SETTING menu.

12. HOME SETTING

Home parameters can be set on this page.

HOME FUNC

Turn home function on or off.

SELECT MODE (AUTOPAN/ SEQUENCE/ CRUISE/ PRESET)

Dome will go to execute this mode function when home function is enabled and the

“RETURN TIME” is reached.

RETURN TIME (MINUTES)

Dome will start to count “RETURN TIME” when user move the camera to arbitrary

position.

AUTOPAN/ SEQUENCE LINE/ CRUISE/ PRESET POS