User manual

•
Enter the Email Address of the recipient. Optionally, multiple email addresses can be entered. Separate
multiple e-mail addresses by commas or semi-colons.
•
Enter the Email Transmission Delay. This option sets the delay time in minutes that will pass after the
sensor has been triggered before the transmission will start.
•
Enter the Threshold number. This value sets the number of event lines to be included in the sent emails. De-
pending on the settings, numerous events can be registered by the Server: detected motion, triggered sensor,
activated control, video loss. Each event can be reported individually by e-mail, however, this may flood the recip-
ient e-mail inbox; as a means to avoid this, multiple events (lines) can be sent in a single e-mail.
Note
When setting the Threshold number, remem-
ber that an e-mail will not be sent until the
necessary number of events has occurred
to reach the threshold.
3.
Fill in the Send From section:
•
Enter the Name of the sender (Optional).
•
Enter the Email Address of the sender.
4.
Fill in the SMTP Server section: Depending on the location, each Internet provider has specific SMTP information.
Obtain this information from the Internet provider.
a.
Enter the IP Address of the SMTP server. Example: smtp.bellsympatico.com
b.
Enter the Port number. It is not usually necessary to change the port number. Most SMTP servers have a default
port. For more information on default Ports, please contact the email account manager.
c.
Enter the Login Method. "None" is the default method; otherwise, please contact the email account manager.
d.
Enter the User Name and Password: Some Internet providers require user names and passwords to send
out emails, if this is the case, please enter them accordingly.
Related Topics: Sensor Setup | Intelli-Guard™ | VideoLogix™
61ELMO DVR User Manual v5.01
Email SetupELMO DVR Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/