User manual

configured in this menu are also used by Intelli-Zone™ and the Preset Touring

function.

To configure the presets for a PTZ camera, do the following:

1. Enter the PTZ mode by clicking on the PTZ camera on the main screen.

2. Locate the Preset menu in the bottom of the screen:

Click Get Preset. The button will become Set Preset

4. Program the desired Preset (see instructions below).

Note

PTZ function has to be enabled and Camera

ID has to be assigned for all PTZ cameras

in Hardware Setup.

AFTER programming the preset, click the Preset number (1-10). The preset gets recorded once the preset number

is clicked.

Repeat Steps 4-5 to configure all presets.

7. Exit PTZ mode

Program the desired Preset with the PTZ window buttons:

1. Adjust camera Pan-Tilt position by clicking the arrows up and down for Tilt; left and right for Pan.

2. Increase/Decrease Pan/Tilt speed by clicking the arrows. The higher the speed, the faster the PTZ camera will move

in response to the user command.

Focus and Zoom in/out by clicking + and - signs

Program the desired Preset with the in-cameo PTZ function:

1. Point with a mouse cursor in the desired direction. An arrow will appear.

2. Hold down the left mouse button, the camera will move in the desired direction.

Focus and Zoom in/out with the Focus and Zoom buttons on the right side of the window.

Program the desired Preset with keyboard:

Use Num Pad arrow buttons (4 and 6 for Pan; 2 and 8 for Tilt; - and + for Zoom in/out functions)

Related Topics: Camera Setup | Preset Touring | Intelli-Zone™

12ELMO DVR User Manual v5.01

PTZ modeELMO DVR Server

XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/