Specifications

58
IP cam configurations.
6. Save the configuration and you can start to use the IP CAM.
!
Note
1. Make sure your Network is working. You can ping your DVR in another
Window PC.
2. Maker sure your IP cam connects to the network. You can detect the IP cam via
the software provided by IP CAM supplier to make sure it works or not.
3. Make sure the IP CAM model you select is correct.
4. If DVR is in the LAN (Local Area Network) network, the network mask o
f
DVR and IP CAM must the same. Please refer to the Chapter 5-8 Network
Setting
5. If DVR is in the WAN(Wide Area Network) and your IP CAM is behind the
Firewall/NAT, Please assign a port to the IP CAM.
6. If you enable the Authentication function of IP CAM in the software provided
b
y IP cam supplier, please make sure you enter the right Username & Password
in the DVR setup.
7. This version only supports MJPEG compression codec
8. This version doesn’t support PTZ, audio and resolution configuration on IP
cam and will be supported in the later version.
9. When setting color parameters of IP camera, the response time will depend on
network bandwidth.