Specifications

53
7. Detection
: Set the Motion Sensitivity, Motion Detection Area and Camera
Mask.
7-1 Sensitivity (10/20/30/40/50/60/70/80/90/100): You can set the sensitivity of motion
detection during recording. It is recommended to adjust the setting to 100 in order to
prevent any data loss. However, in some special conditions, the system continues to
record even when no motion has occurred. This will result in a considerable amount of
useless data being recorded. In such a case, it is recommended to lower the sensitivity
setting to avoid wasting hard disk.
7-2 Motion Detection Area: This is used to set the motion detection area.
 Method One
(1) Click
(2) Select “Set Detection Area” and use the mouse to drag an area to be detected.
(3) You can set many detection areas by dragging mouse again.
 Method Two
(1) Click
(2) Select “Clear Detection Area” and use the mouse to drag a non-detection area.
(3) Drag the mouse again to set more non-detection areas.
7-3 Camera Mask: If you enable “Camera mask detection”, live monitor will show
“ Mask” and DVR will record a log to remind the user when camera is masked.