Specifications

140
If you select JBOD, DVR will prompt you the following message.
If you click “Ye s”, the following message will occur and reboot DVR after you press
“OK” to finish the RAID configuration.
!
Note
 If the interface between RAID Box and DVR system is through IDE and you
select JBOD mode, DVR will just support max two channel HDDs.
 If the interface between RAID Box and DVR system is through SATA
interface, it can’t support JBOD mode.
 Select RAID mode
If you select RAID mode, it will show the following menu for you to assign RAID or
HOT Spare to each RAID Disk and list all Disk information.
Please note below threes remarks when you make the selection,
1. RAID and Hot spare can’t be selected in the same channel(HDD).
2. Only one Hot spare HDD can be selected.
3. It’s meaningless to select Hot spare in RAID Level 0.
Step 4: Select RAID Level