Owner manual

610.44520.40.000 24 / 52 © Gardner Denver Deutschland GmbH
Installation
2FC4152-1NE00 ... 2FC4222-1NE00
B A
C
D
X1
X2
E
F
1ne2bhxn101
Fig. 12: Terminal box 2FC4152-1NE00 ... 2FC4222-
1NE00

Mains cable L1, L2, L3, PE

PE connection mains cable and motor cable

Shielded control cable

Shield connection for the control cable::
 1 Prepare cable

 2 Pass the cable through the eye of the
shield sheet and bend the eye.

 3 Screw together eye and shield sheet:
– The shielding must have large−surface
contact to the shield sheet.
– The shielding must be connected tightly
to the shield sheet.

0.7 Nm
6lb-in
PES

Potential free terminal

Control terminal module
X1 Terminal strip for mains connection and relay
output connection
X2 Terminal strip for motor connection and motor
temperature monitoring
PES HF shield termination by large−surface
connection to PE
Mains contactor, fuses and cable cross-
sections
NOTE
Observe the following when using earth
leakage circuit breakers:
 Install earth leakage circuit breakers only
between the supply mains and the frequency
inverter.
 The earth leakage circuit breaker may trip
incorrectly if several drives are
simultaneously connected to the mains.
Frequency
inverter
Required mains
contactor K1
Type [kW] [kW] FI
2)
2FC4152-
1NE00
1,5
2FC4222-
1NE00
2,2
4
≥30 m
A
Fuses and cable cross sections Frequency
inverter
Installation according
to EN 60204−1
Installation
according to
UL 1)
Type
 
L1, L2,
L3, PE
[mm
2
]

L1, L2,
L3, PE
[AWG]
2FC4152-
1NE00
M6 A B6 A 1 5 A 18
2FC4222-
1NE00
M10
A
B10 A 1,5 10 A 16
 Fuse
 Circuit−breaker
1)
Use only UL−approved cables, fuses and fuse
holders. UL−fuse: voltage 500 ... 600 V,
tripping characteristic "H", "K5" or "CC"
2)
Pulse current sensitive or all current sensitive
e.l.c.b.