Manual Glass Kiln

Replacing the Thermocouple
1 Unplug the kiln.
2 Remove the four screws holding the controller to
the front of the kiln. Carefully remove the control
-
ler.
3 Remove thetwo thermocouple wiresfrom theback
ofthecontroller.Theyareheldinplacebybuttonor
lever typeconnectors. Toremove thewires, liftthe
levers (or press down on the connector buttons)
and pull the wires out.
4 Remove the back cover of the kiln.
5 The thermocouple is located in the back of the fir
-
ingchamber,heldinplacebyametalband.Remove
the thermocouple from the kiln.
6 Bend the new thermocouple between porcelain in
-
sulators. The thermocouple end should be two in
-
sulators long after bending.
7 Pushthenewther
-
mocouple into the
hole in the firing
chamber. The
twisted end must
extendinto thefir
-
ingchamberby½”
- ¾”. Make sure
the band holds the
thermocouple.
Otherwise, the
thermocouple can
be pushed out, re
-
sulting in an overfire.
8 Thread the thermocouple wires down to the con
-
troller opening at the front of the kiln. Keep the
thermocouple wires away from electrical compo-
nents and other wires.
9 Strip½” of insulation from the endsofthethermo-
couple wires.
10 Attach thewires tothe backof the controller.One
wire is yellow, the other red. Make sure the wires
connect to the correct terminals, which are color
coded.
11 Install the controller and back cover of the kiln.
Replacing a Relay or Transformer
1 Unplug the kiln.
2 Place the kiln on its back.
3 Removethescrews holding thesheet metalbottom
tothekiln.Tiltthebottomforwardtogainaccessto
the transformer and relay.
18
The band must secure the thermocou
-
ple. Otherwise the kiln could overfire.
Removing the thermocouple.