Datasheet

www.elma.com Elmaset C | 2_9
C
2: Front Panels for Plug-In Units
2.2.2.7 Card Holder acc. to IEC Standard
•
By using the zinc die-cast card holder, flat front panels and EMC front panels acc. to
IEC can be connected to a PC card to form a plug-in unit
• The card can be mounted both in the standard position and offset 1 HP (5.08 mm)
• Scope of delivery:
• Card holder
• Assembly material see below
2.2.2.7 Card Holder without Swivel Stop
Description Application D Part-No.
Card holder without swivel stop
Without injector / ejec-
tor handle
M2.5 61-156
Assembly Material
Description Application Part-No.
Cross recessed countersunk screw M2.5 x 8 For card holder 5322-08
Torx countersunk screw M2.5 x 8, size T8 For card holder 
Slotted pan head screw M2.5 x 6 For printed board 
Torx cylinder head screw M2.5 x 6, size T8 For printed board 
2.2.2.8 Card Holder/End Piece without ESD Pin
• Scope of delivery:
• End piece card holder (zinc die-cast, nickel plated)
• Assembly material
(screws M2.5 for fixing of front panel/card holder/printed board)
Card Holder/End Piece without ESD Pin
Description Part-No.
Top 81-018-01
Bottom 81-019-01