Installation Guide

Operating Instructions Continued
www.ellasbubbles.com Page 17 03/18
5. Using the Hydro Massage:
To activate and deactivate the hydro massage pump, push the on/off the control button
(Page #9). There are two types of hydro jets in your walk in bath; adjustable and non-
adjustable types. Simply push on the head of an adjustable jet and turn the head in the
desired position. The in-line water heater will activate with the Hydro pump. An air ow
rate control dial can be found over the shoulder of the seating area. Turning the knob
clockwise will reduce the amount of air introduced into the hydro system. Adjust according
to personal preference.
6. Using the Air Massage
To activate and deactivate the air massage pump, push the on/off control button (Page
#10). Notice, when adding cool air into the bath water it can lower the water temperature.
7. Using the Ozone Sterilization
To activate and deactivate the ozone sterilization, push the on/off control button
(Page #12). Turn the ozone on for 10 minutes for every 30 minutes of tub use.
8. Using the Heated Backseat (Optional Feature)
To activate and deactivate the heated backseat, push the on/off control button
(Page #14). Turn on for warmth while the tub is lling up and draining.
NOTE: When the other pumps (air and hydro) are off and the Ozone generator is left on,
you will be able to hear the buzzing of the Ozone generator, this is normal and only needs
to be turned off.