Installation Guide

●Please read these instructions in full before installing
●Check that the bathtub has been installed to the manufacturer’s instructions.
Please note - All product is supplied without a tray.
IMPORTANT
GENERAL SAFETY INSTRUCTIONS
●Opening wall adjustments
48"Slider - adjustment = (46.02"-48")x78"
60"Slider - adjustment = (58.03"-60")x78"
●This product is heavy and requires two people during lifting and operations.
●Glass is delicate, support on cardboard to minimise risk of damage.
●Do not fix the wall profile to newly plastered, painted or papered walls as chemical
reaction may cause discolouration to the surface finish.
●lmportant: The wall plugs included in this pack are for solid walls only. If the product
is to be mounted on a partition or stud wall, specialised fixings should be purchased
separately.
●Fixing tips; A piece of insulating tape or a couple of layers of masking tape applied to
the wall before marking out the fixing holes will help stop the drill from wandering,
particularly on tiled surfaces.
●When working near a basin or bath insert the plug into the waste, this will help you
avoid losing small parts. Also take care not to drop accessories or tools onto the
bath or basin, use a towel or bathmat to protect delicate surfaces.
●CAUTION!
Before drilling into any walls check that there are no hidden cables or pipes. Exercise
great care when using power tools near water. The use of a residual current device
(RCD) or cordless drill is recommended. Always double check the positioning and
measurements before drilling holes.
Tools required (not supplied)
Electric drill
Drill(Ø3.2mm)
Drill(Ø6mm)
Cross head
screw driver
Spirit level
Tape measure
Rubber hammer
Knife
Silicone sealant
Pencil
1
SIL
IC
O
N
E