Installation Guide

4.
5.
2.5
2.5
- Loose the back nut E of 8HD19 to disassemble 8HD19 to part E,
F and G. Insert back nut E into the holes on the rail profile.
-Peel off the skin of paper on the F. Insert F also into the hole to fix
nut E tightly on the rail profile.
- Disassemble wall bracket 8HD20 to part H and I with hex key 8HD24.
- Put part H on the other end of rail profile 8HD08.
E
E
E
E
H
I
F
F
G
F
F
F
8HD19
8HD24
2.5
X 2
X 1
a. Insert the rail profile into wall bracket of fixed glass panel side.
b. Measure the rail profile with spirit level to make sure the rail profile
is horizontal. Match the holes on rail profile and fix glass panel.
c. Mark the position of 8HD20 accordingly.
d. Drill the holes (∮6mm) according to the marks and insert the wall
plugs 8HD11(2X) into the holes.
e. Fix the seat I on the wall with screw 8HD13(2X)
f. Fasten the wall bracket with seat by hex key 8HD24.
φ
6
b
a
d
c
e
f
8HD20
X 1
X 2
8HD11
8HD13
X 2
ST4X40
8HD24
2.5
X 1
6
8HD24
8HD20
8HD19
8HD19
8HD19
8HD24
8HD11
8HD13