Installation Guide

4.
2.5
- Loose the back nut E of 6HD19 to disassemble 6HD19 to part E,
F and G. Insert back nut E into the holes on the rail profile.
-Peel off the skin of paper on the F. Insert F also into the hole to fix
nut E tightly on the rail profile.
- Disassemble wall bracket 6HD20 to part H and I with hex key 6HD24.
- Put part H on the other end of rail profile 6HD08.
E
E
E
E
H
I
F
F
G
F
F
F
6HD19
6HD24
2.5
X 2
X 1
6HD20
X 1
6HD24
6HD20
6HD19
6HD19
6HD19
5.
2.5
a. Insert the rail profile into wall bracket of fixed glass panel side.
b. Measure the rail profile with spirit level to make sure the rail profile
is horizontal. Match the holes on rail profile and fix glass panel.
c. Mark the position of 6HD20 accordingly.
d. Drill the holes (∮6mm) according to the marks and insert the wall
plugs 6HD11(2X) into the holes.
e. Fix the seat I on the wall with screw 6HD13(2X)
f. Fasten the wall bracket with seat by hex key 6HD24.
φ
6
b
a
d
c
e
f
X 2
6HD11
6HD13
X 2
ST4X40
6HD24
2.5
X 1
6
6HD24
6HD11
6HD13
6HD03