Installation Instructions

Warranty Activation Form
ellasbubbles.com | 9
Upon completing the installation of an Ella Walk In Bath, the following Warranty Activation Form must be completed, signed by both
the customer and installer, and returned to Ella’s Bubbles, LLC. In order for the Warranty to be activated (faxed, scanned, or emailed,
or hard copy mailed).
TO BE INITIALED BY THE INSTALLER(S)
_________ Tub is level in all directions and all support legs are touching the ground.
_________ Tub is installed on a dedicated 30 Amp GFCI protected circuit using 10 gauge wire
_________ Frame of the tub has been properly grounded.
_________ Door Seal has been cleaned with rubbing alcohol to remove any dust or debris left over from construction.
_________ Temperature Control Valve operated on both hot and cold settings.
_________ Both diverters function properly.
_________ Hand Shower functions on all settings without leaking.
_________ All supply lines have been checked for leaks while both diverters are on.
_________ Drains open and close properly, and the locking nut has been tightened on both stoppers.
_________ Door seal is water tight after tub has been lled for a minimum of 20 minutes.
_________ After running for a minimum of 20 minutes both the Hydro and Air Pumps are functioning properly and all connections to
the pumps and jets are water tight.
_________ Chromatherapy Light and the Ozone Sterilization are working properly. (When the Ozone is on by itself it will make a light
humming noise).
_________ All drain ttings have been checked for leaks while the tub is draining.
_________ Unit is installed with access to both plumbing and electrical connections.
INSTALLER’S INFORMATION
Name
Address City State Zip
Telephone Email
Date
Signature