User Manual

RFJA-32B-SL
Switch unit for shutters
RFJA-32B-SL
Characteristics
• The switching unit for blinds has 2 output channels used to control garage doors,
gates, blinds, awnings, etc…
• It can be combined with system components iNELS RF Control
2
with RFIO
2
protocol.
• The BOX design lets you mount it right in an installation box, a ceiling or motor drive cover.
• Short presses of the controller enable tilting of lamellas, and a long press enables you to draw the blinds up
or down to the end position.
• Each of the units may be controlled by up to 25 channels (1 channel represents one assigned controller).
• The programming button on the unit is also used for manual control of the output.
• For components it is possible to set the repeater function via the RFAF / USB service device.
• Range up to 200 m (in open space), if the signal is insu cient between the controller and unit, use the
signal repeater RFRP-20 or protocol component RFIO
2
that support this feature.
• Communication frequency with bidirectional protocol iNELS RF Control
2
(RFIO
2
).
Detailed manual
Installationoptions
mounting into a non-conducting drive housing fl ush mounting ceiling mounted