Technical data
28
DA3-22M
CIB+
CIB -
AC 230V
Universal dimming actuator, 2-channel DA3-22M
symbol description
R
resistive
ordinary light bulb, halogen lamp
L
inductive
coiled transformer for low-voltage halogen lamps
C
capacitive
electronic transformer for low-voltage halogen lamps
LED
LED lamps and LED light sources, 230 V
ESL
dimmable energy-saving uorescent tubes
2x inputs, switching potential L
YES, input for external thermo sensor TC/TZ
+15 .. +35°C; 0.3°C from the range
2x buttons, 4x potenciometers
on front panel
2 contactless MOSFET 230V AC
resistive (R), inductive (L), capacitive(C)*, LED, ESL
YES
3.75 kV, SELV according to EN 60950
max. 500 V AC
10 VA
400 VA for each channel
2x yellow LED
- thermal
- short-term overload
- long-term overload
CIB
27 V DC/30 mA, from CIB BUS
green LED RUN
max. 2.5 mm
2
/1.5 mm
2
with sleeve
-20 .. +35 °C
-30 .. +70 °C
IP 20 device, IP 40 mounting in the switchboard
FR-0
class 2
2.5 kV
II.
2
vertical
switchboard on DIN rail EN 60715
3-MODULE
90 x 52 x 65 mm
136 g
It is used to control light intensity of dimmable energy saving lamps (ESL), LED
bulbs and R, L, C with power suppl 230 V AC, but you can also use the actuator for
switching appliances.
DA3-22M
integrates 2 binary inputs, which allow 230V AC voltage connection
(normal wall switch contacts).
MOSFET contactless output 230V AC, maximum load is 2x 400 VA.
Type of light source is set by switch on the front panel.
Setting min. brightness by potentiometer on the front panel, the fl ashing of
diff erent types of light sources is eliminated.
By buttons on the front panel, you can manually switch on or off the corresponding
output.
Electronic overcurrent and thermal protection - switch off output in case of
overload short circuit and overheating.
DA3-22M in 3-MODULE version is designed for mounting into switchboard on DIN
rail EN60715
Input:
Temperature measuring:
Scope and accuracy of temp. measurement:
Number of control buttons:
Output:
Load type:
Galvanic separation:
Insulation voltage between outputs
and built-in circuits:
Isolation voltage between particular
power:
Minimal controlled load:
Maximal controlled load:
Output indication ON/OFF:
Device protection:
Installation BUS:
Supply voltage/rated current:
Status indication unit:
Terminal:
Operating temperature:
Storing temperature:
Protection degree:
Heat and fi re resistance category:
Anti-stroke category (immunity):
Rated impulse voltage:
Overvoltage category:
Pollution degree:
Operating position:
Installation:
Design:
Dimensions:
Weight:
INPUTS
Types of connectable loads:
TECHNICAL PARAMETERS
n
n
n
n
n
n
n
n
List of dimmable light sources can be found here: http://www.elkoep.com/solutions/
Temperature sensor TC / TZ
Temperature sensor TC / TZ
*Attention: It is not allowed, to connect loads of inductive and capacitive character, at
the same time.
DIMENSIONS AND WEIGHT
CONNECTION
OPERATING CONDITIONS
POWER SUPPLY
COMMUNICATION
OUTPUTS
type of source
DA3-22M 8595188132626
EAN code