Installation Sheet

ManualsBrandsElkay ManualsDrinking FountainsFiltered 8 GPH EZH2O ADA Light Gray Bi-Level Drinking Fountain with Bottle Filling Station

INSTRUCTIONS TO ACCESS PROGRAMMING BUTTON

1) Remove lower cover on refrigerated unit by removing (4) screws.

2) Button is located in lower right corner of unit (See Fig. 13).

Programming

Button

FIG. 13

Filter Label

Location

FIG. 12

INSTRUCTIONS FOR REPLACING FILTERS

1) Remove lower cover on left hand unit by removing (4) screws (See Fig. 5, Pg. 6).

2) Turn off water supply; dispense water to relieve pressure.

3) Remove power by unplugging cooler.

4) Turn used lter counterclockwise 1/4 turn to remove from lter head.

5) Remove cap from new lter and use to seal used lter.

6) Insert new lter into existing lter head and turn fully clockwise. Make sure you can read the label on the front of the lter once it is installed.

(See Fig. 16 on Pg. 19).

7) Plug in unit to restore power.

8) Turn on water supply and run a minimum of two gallons of water through the lter to purge air any ne carbon particles from lter. Also run

water through bottle ller.

Note: Filter status light will automatically reset once new lter is installed.

FINAL INSTALLATION (FILTER)

21) Remove lter from carton, remove protective cap, attach lter to lter head by rmly

inserting into head and rotating lter clockwise. Ensure that lter label can be read when

lter is installed. (See Fig. 12)

22) Turn water supply on and inspect for leaks. In both cooler and Bottle Filler. Fix all leaks

before continuing.

23) Once cooler and bottle lter have been inspected for leaks and any leaks corrected,

plug cooler into wall.

24) Reinstall two mounting screws from rst step above. Caution do not over tighten screws.

25) Once power is applied to the cooler the GREEN LED light will illuminate on the bottle

ller showing good lter status along with the LCD Bottle Counter.

26) Verify proper dispensing by placing cup, hand, or any opaque object in front of sensor

area and verify that the water dispenses. Note: the rst initial dispenses might have air

in line which may cause a sputter. This will be eliminated when all air is purged from the

line.

27) Once unit tests out, install Lower Panels back on water coolers. (See pages 12-13 for

versatile wrapper installation). Units are now ready for use.

Back of Filter

Page 8

ENLZSTL8WS_1G

1000004543 (Rev. C - 07/19)