Installation Sheet

INSTALLATION OF COOLER
4) Remove the four (4) screws holding the lower front panel at the bottom of each cooler. Remove front panel by pulling straight down and set
aside. (Fig. 5)
5) Hang only the refrigerated cooler on the hanger bracket. Be certain hanger bracket is properly in the slots on the cooler backs
as shown in Figures 1 (Pg. 2), 2 (Pg.3), 3 (Pg. 4), and (Fig. 4, Pg. 5).
6) Hang the non-refrigerated cooler on the hanger bracket. Be certain hanger bracket is engaged properly in the slots on the cooler backs as shown in
Figures 1, (Pg. 2), 2 (Pg. 3), 3 (Pg. 4), and 4 (Pg. 5).
7) Unband the loose wires in the refrigerated cooler for the NFC board. Stretch it out and thread through the left side of the refrigerated cooler
and into the right side of the non-refrigerated cooler. Plug into the NFC board that is behind the lter head.
8) Secure each cooler frame to wall by installing (2) screws and washers (not supplied). See pictures below.
Make sure the screws engage in a structural member.
9) Connect the supply water to the lter 3/8” copper inlet tube.
10) Connect the waterline from the outlet of the lter to the inlet of the evaporator in the refrigerated cooler by inserting it into the quick connector.
11) Connect the waterline from the solenoid in the non-refrigerated cooler to the open 1/4” inch tee tting in the refrigerated cooler.
12) Find your cooler conguration on page 11 and connect the drain assembly together.
13) Install trap. Remove the slip nut and gasket from the trap and install them on the cooler waste line making sure that the end of the waste line ts into
the trap. Assemble the slip nut and gasket to the trap and tighten securely.
IMPORTANT: If it is necessary to cut the drain, loosen the screw at the black rubber boot and remove tube, check for leaks after re-assembly.
HANGER BRACKETS INSTALLATION
1) Remove hanger bracket fastened to back of coolers by removing one (1) screw.
2) Determine your mounting conguration from the gures shown on pages 2 - 5. Refrigeration unit must be on right hand side.
IMPORTANT NOTE: If the Bottle Filler is to be mounted on the left hand cooler, a basin assembly change will be needed.
Determine your conguration by referring to the Conguration Instructions on page 9 prior to continuing.
3) Mount the hanger bracket as shown in Figures 1 - 4 (Pages 2 - 5).
NOTE: Hanger Bracket MUST be supported securely. Add xture support carrier if wall will not provide adequate support. Anchor hanger
securely to wall using all six (6) 1/4 in. dia. mountin holes.
IMPORTANT: 5-7/8 in. (150 mm) dimension from wall to centerline of trap must be maintained for proper t.
FIG. 6 FIG. 7
FIG. 5
Page 6
ENLZSTL8WS_1G
1000004543 (Rev. C - 07/19)