Installation Sheet
PRINTED IN U.S.A.
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.834.4816
ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484 • www.elkay.com
REPAIR SERVICE INFORMATION TOLL FREE NUMBER 1.800.260.6640
*INCLUDES RELAY & OVERLOAD. IF
UNDER WARRANTY, REPLACE WITH SAME
COMPRESSOR USED IN ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the
above water coolers or orders for repair parts MUST
include Model No. and Serial No. of cooler, name and
part number of replacement part.
115V PARTS LIST
1
2
3
*4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
NS
NS
ITEM
NO.
PART
NO.
DESCRIPTION
28401C
0000001337
36216C
36322C
56092C
56229C
66703C
1000001877
1000004564
1000004572
56073C
98734C
1000001600
1000004568
98775C
98776C
98777C
98778C
98898C
0000000238
98724C
1000001812
56237C
1000001602
1000004559
56213C
1000004547
1000004550
98773C
27416C
27413C
Hanger Bracket
Basin - Stainless Steel
Wiring - Front/Side Push Bar
Compr - Service Pak 115V EMIS70HHR
Tube - Poly (72”)
Assy - Shroud - Upper (Front Side Push)
Drier
Kit - Drain Replacement (Bottle Filler) (Bracket, Tube, Fitting, Clamp)
Kit - Regular/Holder/Nut
Kit - Solenoid Valve/Regulator Assembly
Kit - Flexi Bubbler/“O”-Ring/Nut
Kit - Pushbar (Front/Side) EZS TL
Kit - Pushbar (Front Only)
Power Cord
Kit - Fan Motor/Blade/Screws/Nut
Kit - Condenser/Drier/Wire Ties
Kit - Compr Mtg Hdwe/Grommets/Clips/Studs
Kit - Heatx/Drier
Kit - Hardware
Kit - 115V Electricals (Relay, Overload, Cover)
Kit - Evap. Replacement
Kit - Bottle Filler Drain
Shroud
Kit - 75583C Elbow 5/16" x 1/4" (3 Pack)
Wire Assy - Jumper
Access Panel
Harness - Cooler
Wire - 6” Jumper
Kit - Cold Control
Wrapper Stainless Steel
Wrapper Light Grey
NS = Not Shown
BOTTLE FILLER
REPLACEMENT PART KITS
NS
30
31
NS
32
33
34
NS
35
36
ITEM
NO.
PART NO. DESCRIPTION
98546C
98549C
1000004573
1000005077
1000002433
1000005219
1000004544
1000004436
1000004546
1000004549
Kit - Aerator Replacement
Kit - Hardware & Waterway (BF)
Kit - Solenoid 120V (BF)
Nameplate - Elkay Filtered
Kit - Top Cover Assy (BF)
Kit - IR Sensor K+
Kit - Alpha Numeric LED Board
Kit - Tower/Basin Gasket
Harness - Bottle Filler
Harness - LED/IR Board
NS = Not Shown
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modications not expressly approved could void your authority to use this equipment
This device complies with Part 15 of the FCC Rules. Operation to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de license. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
ATTENTION:
If the product serial number is before 190424189, please refer to archived
documents section of Elkay.com for the most accurate parts list.
(www.elkay.com/archived-documents)
Page 12
ENLZS8WS_1G
1000004538 (Rev. C - 07/19)