Installation Sheet

SPOUT ASSEMBLY
CARTRIDGE NUT
CARTRIDGE/VALVE
HANDLE
ALIGNMENT
SCREW
HANDLE
INSTALL
TEMPERATURE
INDICATOR
RING
LOGO
SET SCREW
SPRAY HEAD
HOSE GUIDE
WASHER
LOCK NUT
HOSE
DIVERTER
INSTALL
SPOUT
WASHER
Elkay recommends installation by a licensed plumber.
Install Spray and Hose (if included)
1. Remove locknut and washer from sprayer base assembly and
place assembly in far right hole of sink deck. Reassemble washer
and locknut on shank from under sink. Tighten.
2. Insert hose through sprayer base assembly then route back up
through the center hole for the faucet. Thread hose onto faucet
and tighten.
Install Faucet
1. Be sure mounting surface is clean and dry. Apply plumbers
putty or silicon sealer to bottom of escutcheon gasket.
2. Place faucet shanks through holes in sink.
3. Fasten faucet to deck from underneath sink using washers and
nuts. Tighten.
4. Clean extra plumbers putty or silicone from around escutcheon.
5. Connect supply lines to faucet shanks and tighten.
6. Place washer on the waterway spout connector and thread spout
assembly by hand until snug.
7. Remove aerator from spout and Flush water lines to remove dirt
and sediment from water lines. Replace aerator.
Install Handles (if required)
1. Ensure cartridge (valve) is in the “off” position. (Fully counter
clockwise for Cold and Fully clockwise for Hot.)
2. Insert handle over cartridge stem
3. Insert alignment screw in handle hole towards back of sink. Screw
in only half way.
4. Place Red Temperature Indicator Ring in the top of the hot side
handle and the Blue ring in the top of the Cold side handle.
5. Place Logo part in top of both handles so logo can be read from
front of sink.
6. Thread handle set screw into each handle and tighten.
Change Diverter Valve (If Side Sprayer Equipped)
1. From top of sink, Unscrew spout and pull upward to remove.
2. Unscrew waterway spout connector from main waterway (Wrench
flats provided).
3. Pull diverter valve out of waterway and replace with new diverter in
same orientation.
4. Thread waterway spout connector into main waterway and tighten.
5. Thread spout assembly on waterway and hand tighten.