Installation Sheet
BASE ESCUTCHEON
LOCK PLATE
FAUCET SHANK
MOUNTING NUT
MOUNTING GASKET
Elkay recommends installation by a licensed plumber.
Install Faucet
1. Remove mounting nut, mounting gasket and lock plate from faucet shank.
2. Be sure mounting surface is clean and dry. Apply plumbers putty or
silicon sealer to bottom of base escutcheon. This faucet requires a
maximum faucet hole size of 1-1/2”. A hole larger than 1-1/2” will affect
the performance of the faucet.
3. Place faucet shank through hole in sink and center over hole.
4. Fasten faucet to deck from underneath sink using washer, lock plate and
mounting nut. Tighten.
5. Clean extra plumbers putty or silicone from around escutcheon.
6. Connect supply lines to supply valves and tighten.
7. Remove aerator from spout and Flush water lines to remove dirt and
sediment from water lines. Replace aerator.
Install Handles (if required)
1. Ensure cartridge (valve) is in the “off” position. (Fully counter clockwise
for Cold and Fully clockwise for Hot.)
2. Insert handle over cartridge stem
3. Insert alignment screw in handle hole towards back of sink. Screw in
only half way.
4. Place Red Temperature Indicator Ring in the top of the hot side handle
and the Blue ring in the top of the Cold side handle.
5. Place Logo part in top of both handles so logo can be read from front of
sink.
6. Thread handle set screw into each handle and tighten.